"Complaint of not running, unplugged on arrival with load in unit. F8e1 (no fill, long fill) only error in history. Load in unit was a couple pillows and was set to deep water wash.Ran diagnostic cycle. Not filling with hot water, hot water valve turned off., turned on and ran again, both valves working, completed test cycle, does make noise like squeaking belt in spin.Lower unit inspection found what looked to be pillow filler under unit that had been sucked into belt drive, cleared. Recalibrated unit. Belt still a little noisy but unit runs ok. Ran drain and spin to test belt at max speed and spinning out fine, noise goes away as it gets to speed.Quoted for cam/belt/labor, but is working as is.Put load back in washer and ran on bulky deep water. Filled and went into agitation fine.Had quoted service call after explaining not covered under warranty on arrival. Went to collect and son said it was his moms , she didnt make service call ( adult son did) and is refusing to pay. Nothing collected, but let son know it will be marked failure to pay and we wouldnt do future service."

"Replaced control and harness, tie wrapped drain hose to fill lines. Leveled unit ( back feet are all the way up, fronts almost all the way down ), these units do shake. Some tiles are higher then others on floor, so if moves it is no longer level.Ran normal cycle on auto and filled fine to proper level; used 1 W11643701 (HARNESS LOWER) from stock"

"Replaced rotor, ran calibration cycle. Completed and ran rapid wash cycle. Unit went through sensing/fill and into agitation fine. Cancelled and drained fine n?e fine"

"Replaced control/console and door switch. Water was in unit on arrival, selected drain and unit drained out fine. Ran diagnostic cycle fine. Ran normal cycle and verified unit doesnt just start when door is closed, but will resume a cycle already in progress."

"Unit doesnt match call.This is a ge dryer space maker dryer DSKP333EC6WW serial TM500688C . Cs does not speak English well but says she pays per month for warranty, verified with office un matching unit, cs will have to contact contract provider to set service on correct unit.Took photos of unit, serial number could be 2019 or 2007 assuming 2019, just a bit beat up."