Dan

"Delivery Date is June 25,2025. Service pointer# W11782244. Found the in line fuse is good, but when the door is open and closed the contact separates in the fuse and power is lost. I confirmed the control and user interface are not faulty. Was able to operate the dishwasher. The service kit for the in line fuse in needed to repair and complete this job. ; schdld next appmnt for 5/12 TUE AM"

"Confirmed customer complaint, out door is scratched/dented. Replaced the outer door and inner door . The door opens and closes properly,. The microwave has yet to be installed, New Construction Build. Job is complete."

"Found right front burner faulty. Replaced right front burner switch and tested for operation of the burner. Also found rr burner and switch shorted. Replaced switch and burner and the knob was cracked and needed to be replaced, burner was not actually in the off position when the knob looked like it was in the off position. Job is complete."

"Replaced outer tub, spin basket, heater, filter, clutch, slider, thrust, motor rotor, motor stator, gear case, suspension rods, spanner nut wash plate and screw. Tested the washing machine for proper operation. The washing machine is operating properly. Job is complete."

"Confirmed customer complaint, drain pump running continuously, washer was unplugged. Confirmed F3 E1 pressure system fault. Replaced electronic control, calibrated and tested washing machine. Job is complete."

"Confirmed customer complaint, washer was unplugged, drain pump running continuously. Faulty transducer. Replaced electronic control, calibrated and tested operation of the washing machine. Job is complete."

"Customer complaint was with the left side panel of the range getting hot too the touch. Found no issues with the door gasket or door sealing completely. No error codes stored, tested components in diagnostics. I removed the side panel of the range to check the insulation around the oven cavity, tucked the insulation in against the oven cavity near front of range by the door hinge. Tested the oven at 400F. The side panel is not hot too the touch. Customer confirmed the side panel is no longer hot like they had experienced."

"Found F9 E1 fault for long drain. Washer would not start, found lower wire harness broken to drain pump connection. Replaced lower wire harness, cleared fault code, and tested operation of the washing machine. The washing machine is operating correctly. Job is complete.; used 1 W11643701 (HARNESS LOWER) from stock"

"Found wash motor is faulty, also Fault F7 E1 for no heat, heater and thermostat are good. Parts ordered for pre diagnosis are incorrect part numbers. I updated series # 1 for this model #. Ordering correct part numbers for sump and motor assembly, as well as an electronic control. Talked with Randy regarding parts, follow schedule for Monday 11th p.m.; ordrng 1 WPW10605058 (Sump + Motor) and 1 W10854229 (Electronic control)"

"Found gas leak at flex line gas supply from house to range, gas leak at connection to the safety valve/pressure regulator, on the home installation connection, no cracks or issues found with the pressure regulator, documented with Whirlpool tech support case# 23441555, sent over pictures. Safety case# 23417317, Safety is covering trip and diagnosis. Homeowner has been advised to replace the flexible gas line and reinstall the adapter/connection with new pipe sealant connecting the flexible gas line to the pressure regulator. Job is complete.; dspstn on spec-tagged invntry: 1 718-202-G1 COMBUSTIBLE GAS DETECTOR"