Appliance Repair Winsted Connecticut

Advantage Appliance Repair Inc. Rated 5.0 out of 5 stars based on 1 customer reviews

We serviced a
WHIRLPOOL WASHER
Model WTW7120HW0
Near Winsted, CT 06098
Ruben C.
Job Details: 04/11/2024
Rechecked unit has error code for long drain customer says he did two loads then it did not drain had water in tub and lock cust waited for awhile then tried and it drain drain pump is intermitently seizing up replaced drain pump ran diagnostics normal spinning normally and cleared codes ; dspstn on spec-tagged invntry: 1 W11396717 DRAIN PUMP
We serviced a
WHIRLPOOL WASHER
Model WTW7120HW0
Near Winsted, CT 06098
Ruben C.
Job Details: 04/04/2024
Drum had minor dent inside cust was ok with popping it out installed gearcase rotor drum control and harness tested operation normal ran diagnostics normal showed cust agitation and spin; dspstn on spec-tagged invntry: 1 W10734521 SLIDER
We serviced a
WHIRLPOOL WASHER
Model WTW7120HW0
Near Winsted, CT 06098
Ruben C.
Job Details: 03/26/2024
"Received new control defective panel only works on left side if I put old one back the whole panel work custmentioned this time that on agitate noisy sometimes check gearcase found leaking oil ordering control console gearcase. Rotor slider. Inner basket agitator found teeth worn down. Also ordering harness; rqstng P&A on 1 W11449841 (Gearcase) and 1 W10734521 (Slider) and 1 W11260238 (Rotor) and 1 W11568984 (Lower harness) and 1 W10752283 (Agitator) and 1 W11178227 (Basket) and 1 Time (Extra time) and 1 W11419051 (Control) and 1 W11478525 (Panel ui), states that autho needed"
We serviced a
WHIRLPOOL WASHER
Model WTW8127LW1
Near Winsted, CT 06098
Ruben C.
Job Details: 03/14/2024
Checked unit found model did not match serial matched ok per Jenny to change model checked unit ran diagnostics normal advised getting overload error advised cust to balance load
We serviced a
WHIRLPOOL REFRIGERATOR
Model WRT311FZDW01
Near Winsted, CT 06098
Mike K.
Job Details: 02/22/2024
"Unit worked for 4 days and then stopped. Checked evap with black light, no sign of leak. Checked compressor and shows leak at drier, which happened during repair. Used nitrogen and leak detector, another slow leak at drier. Re did joint, pressurized with nitrogen and no bubbles. Pulled into vacuum and held for over 5 minutes. Charged with 4.25oz r134a. Let unit run for 5+ minutes and tested joint again with detector and no bubbles. Return line hot, freezer getting cold. Cs to monitor."
Winsted, Connecticut
10/20/2023
Chuck was terrific!
Overall Experience