"Unit was making noises when tumbling, the rear felt had been folded and damaged, belt and supports a bit worn as well. Replaced supports, idler and belt and unit is running smoother, but will order the felt.; ordrng 1 W10612022 (Drum rear seal), used 1 4392065 (DRYER REPAIR KIT) from stock"

"Sensing wire has become dislodged, reformed wire and is staying with n unit securely. Unit harvesting fine and off , wire in upper position, also working"

Replaced control and evaporator per service pointer. Powered on and unit came back on and running. Cs to monitor.; dspstn on spec-tagged invntry: 1 W11333076 CNTRL-ELEC

"Complaint of unit not cooling in rf section. Compressor/fan running. Measured 16 in fr, 60 in rf. Found partial frost pattern on evap with only first three turnings having any frost. But no block build up.There is a service pointer out for unit over frosting by the rf evap, W11329116. Unit falls within pointer. Cs did hear noise for awhile had just stopped yesterday. Ordering new evap cover and control.Repair will require both doors to come off, defrost of rf evap (service pointer allocated 2x time) office to contact cs when parts come in to schedule return.; ordrng 1 W11167902 (Evaporator cover) and 1 W11333076 (Control) and 1 2xtime (2x time)"

Ck unit upon arrival and found door gasket broken and slime build up and unable to fit back in to groove. Install door gasket from truck stock and ran cycle on unit and checks for leaks while unit running and found no leaks or drips unit now operating to manufacturers specs ; used 1 W11177741 (Door seal) from stock