"Unit not cooling properly after repair, rf is 46, 33 in fr.Unit was on turbo cool for both sections. Set to normal cooling, 10 minutes later found both hot vap fans running. Verified with ge techline that the system will run both at same time. Gave history and he suggested pulling into vacuum and recharging.Pulled into vacuum, charged with nitrogen at 200psi, bubbles tested all joints made, all test fine. Pulled into vacuum again, held from me for 5+ minutes. Preheated new can of f refrigerant and overfilled per techline suggestion. Filled with 68 grams of r600aWith failure to go into diagnostics properly before, will order control and have cs monitor in the mean time.Office to contact when parts come in to schedule return.; rqstng P&A on 1 WR55X46805 (Control) and 1 WR55X44126 (Control (top of left rf door)), ordrng 1 WR86X10094 (3 wat valve assy)"

"Went to replace evap and found unit is running evap fan when going into diagnostics, it is suppose to shut everything down and set three way valve to home/open. This would mean it likely is not setting to home so cannot pull vacuum on whole system. And could be why leak wasnt detected previously.. it was in freezer position test during repair.Randy at office helped fine that unit will go into home position when turned on, can feel valve vibrate, unplug when stopped. Did so and pulled unit into vacuum, leaking. This points to a rf evap leak and replaced rf evap. Burnt hole through new evap stem when brazing, repaired an`d pulled unit into vacuum, held fine. Charged unit with 60 g r600a. Return line getting warm, set unit to cooling rf and verified getting frost pattern on rf evap and bubble tested joints with no leaks found. Cs to monitor"

Replaced gear case assy/basket/actuator/cam/belt. Ran recalibration and diagnostic cycle fine.; dspstn on spec-tagged invntry: 1 WPW10006384 BELT

"Unit stopped cooling, possible fr door was open, turned off overnight and plugged in, didnt seem to be cooling, unplugged on arrival. Plugged in and compressor running,condenser fan running. Evap fan not running. But is shaking turn bu hand and starts to run but is pulsing l. Getting 5vdc from RW to N and 13vdc R the N. Needs new fan, possible control. 336.20 WR55X40445 control. Quoted for fan/control/labor, declined. Collected for service call only"

"Broke out Washplate, collar/spline seized to shaft, hammered and chiseled, but will not come free and is risking damage to gear case assy if not already damaged. Was able to break off hub and get shaft through tub assy. Ordering basket, gear case assy, cam, belt. Will use actuator/ hub on return(returned to office). Wash plate used during visit. Correct orientation of gear case is motor to area front of unit. Cs to examine basket when arrives and call office to schedule install ; ordrng 1 W10752719 (Basket) and 1 W11454734 (Gearcase assy) and 1 W10721967 (Cam) and 1 WPW10006384 (Belt)"