"Unit turned off several times, lights still on, but display showing off the could set temp and turn back on. Repeated failure several times then remained running and has run since. Failure of u/I board, small chance of main control also failing, but by description just the u/I board. Quoted for u/I board and labor. Cs will talk it over with spouse. Collected for service call today. Saved estimate and estimate is good for 7 days."

"Belt cracking, both from supports worn through and post damage, idler damage.Quoted for belt, idler, supports, igniter and labor. Denied. Collected for service call."

"Unit did not desolve soap. Says unit not running properly. Ran a cycle to test. Control lock was on, turned off. filled fine and wash motor running fine.Had several cycles in a row where soap would just be sitting at bottom of unit undesolved.Spray arms are partially clogged, removed what would come out, but still restricted.Ran second time and again filled fine and wash motor running fine. 4-3, 7-1, (wash motor failure and no heat error) errors in history. Ran diagnostic cycle fine. Ordering spray arms and sump assy.Office to contact when parts come in to schedule return.; rqstng P&A on 1 W11085683 (Sump assy) and 1 W11101428 (Lower spray arm), ordrng 1 WPW10448645 (Mid spray arm)"

Unit has a bad bearing. Quoted $269.99 for new gearcase w11454741 and $279 labor customer declined repair

Dryer too close to wall and vent hose pinched.