Appliance Repair in Cornelius, NC

"Customer completed icemaker not working, would make one ice tray after power reset. Ran test 120 , wont advance past. Only showing 00Unit filled with water on valve test. Test 16 showed thermistor test was at -6? after being open for awhile. Techline wanted me to test for voltage at icemaker, DC voltage . found no voltage at icemaker or harness above. Wanted to test voltage at control board. Couldnt test due to being built in refrigerator . Need 2nd man to return to test main control board. Going to bring new icemaker back because its covered under 1hr at warranty . Quoting entire job with main control board but only collecting for labor and 2nd man. Main control is (277.17). Collected labor and 2nd man. Informed customer office will call when parts come in. SR24181965; ordrng 1 W11233631 (Main control) and 1 W11646196 (Ice maker)"

Customer compl unit not drying. Found heater open short. Replaced fro ts. Ran test cycle. Verified proper operation. ; used 1 WP3387747 (ELEMENT) from stock

"Found unit was 18?, ran service tests and found when ramping compressor up to highest level its kicking out. Didnt doit every time but did 2 out of 5 times when running 133hz test 38. Noticed unit doesnt have full frost pattern when running compressor normally. Ineffective compressor. Suggested tapping system and getting pressures. Called Randy to consult. Will need helper to pull unit out. Ordering compressor and filter drier. Putting in for 2xtimeframe ad 2nd man. Informed customer office will call to schedule when parts come in. C#23455473; ordrng 1 W11328338 (Compressor) and 1 WPW10143759 (Filter drier) and 1 W11506635 (Process tube) and 1 2xtimeframe (2xtimeframe), states that autho needed"

Installed main harness wire fuse. Ran unit. Verified proper operation.

Customer had leds out. Replaced all leds from pre id parts in ref. Verified proper operation.

Found f2e1. Unit not responding. Replaced pre id ui control board. Test unit. Verified proper operation.

Returned and replaced ui panel. Entered service diagnostic and ran all service test. All treats passed or showed proper results. Icemaker went through service test and filled with water. Inforned customer to give 24hr for ice production. Verified proper operation.

Installed new gate kit ordered by previous tech. Verified installation and no damage . Showed customer.

Helped EF with compressor job. Observed him successfully install new compressor. Verified proper operation. He has parts used on his ticket.

"F5e2, f7e7 lid lock fault, unable to reach target rpm. Completed diagnostic cycle fine.Complaint of not starting, just hears clicking then spins a little and stops.Cs also complaining of fabric softener function not working. Suspension ok, lower unit looks to k, ran normal cycle, locks and goes into sensing/fill. Cancelled and drained fine. Dispenser was clogged, valves working, cleaned dispenser tray. Replaced actuator, cam and belt. recalibrated and ran diagnostic again fine. Ran normal cycle through sensing and into wash Ashe fine, cancelled and drained fine.; used 1 W10913953 (ACTUATOR), 1 WPW10006384 (BELT), and 1 W10721967 (CAM KIT) from stock"