Dryer not starting. Measured supply power at terminal block and found 15bac across l1-l2 reset the breaker and now getting proper power and drawer starts. Customer must resolve power

Installed new harness and power cord.

Not advancing past rinse and leaking water into basket WHEN unit is off on well water has sediment clogging screens replaced inlet valves calibrated tested operation normal ; used 1 W11210459 (VALVE(USE ORIGINAL HARNESS)) from stock

Range clicking and not powering on. Found terminal block melted and nuts on block not tight. The nuts were just threaded bin a few threads and not tight causing arching and sparking and wires to melt. I gave customer estimate they are going to try to get the repair covered thru people they bought it from

Washer giving F8E1(long/no fill) removed hoses and found good flow. Found cold screen clogged. Cleaned and instructed customer. Ran self test then calibration all checks ok.