"Inspected and found ice chute through the freezer door clogged up with ice, cleared the ice out and dispenser is now dispensing and working, however the dispenser door is not closing properly, will order the part and call for return date.; rqstng P&A on 1 W11130210 (Dispenser flapper assy door)"

Installed new control and recalibrated unit washer went threw normally. Ran a wash and spin checking functions and unit is now working to specs

Installed new controls and interface set times snd heated oven to 350 degrees. Oven now operating and selections working to specs

"Unit not heating, found open heating element. Quoted for heater assy/labor. Accepted. Replaced assy and unit testing fine; used 1 DC97-14486A (ELEMENT) from stock"

"Unit is under 1yr wp warranty per service bench. Complaint that burner turned on by itself. Cs is not at home, mother is there, contacted on phone . Twice burners were turned on without her starting. Rf burner knob was not if full off position on arrival. Each knob working fine in testing, likely getting bumped.Also getting f3e0 error. Display says wi go connecting and will not go beyond first screen of setting, will not start a cycle, screen says oven is hot. Sensor tests fine at 1080 ohms at room temp, same reading at control. Repair would replace ui and control. Called safety. Documented findings and instructed to repair as normal. Ordering control Acu and u/i.Office to contact cs when parts come in to schedule return ; ordrng 1 W11729976 (U/i board) and 1 W11759576 (Control)"